Please note that these steps are general troubleshooting suggestions and may not address all possible causes of the text shifting problem. Again, it is advised to contact a service technician for a solution. If the printer freezes during the Power-On Self Test, this may indicate a defect in the main logic board. In this case, it is recommended to ask a service technician for further assistance.ħ. If all indicator lights are on, there is nothing on the display, and the printer is frozen, this may indicate an internal electronic or firmware error. Ensure that the printer is configured for the correct media type (gap/black mark, continuous, or notch).Ħ. You can calibrate the printer by following the instructions in the manual under the "Calibrate the Ribbon and Media Sensors" section.ĥ. If the printer treats non-continuous labels as continuous labels, it may need to be calibrated for the media being used. You can also try turning the printer off and on again.Ĥ. If changes to the parameter settings have no effect, check the parameters and modify or reset them if necessary. In this case, it is recommended to ask a service technician for assistance.ģ. If the display is missing characters or parts of characters, this may indicate a display problem. Select the language you want to display.Ģ. Use the UP ARROW or DOWN ARROW to scroll through the language options.ĭ. Press "OK" to access the items in this menu.Ĭ. Scroll to the "LANGUAGE" menu on the control panel.ī. If the language is set to a language you cannot read, you can change it by following these steps:Ī. Check the language settings on the control panel. To address the issue of text shifting on the Zebra ZT410 label printer, follow these steps:ġ.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |